B810 Digicom 4G Router 300, Quick Manual

Page: 19 / 24

eng.2
8E4631 4G Router 300 Quick Guide
eng.3
8E4631 4G Router 300 Quick Guide
LED COLOR STATUS DESCRIPTION
7
SYS Green Slow Blinking (500ms duration) Operating normally
Fast Blinking System initialing
Off Power is off
NET
Green On Register to Highest priority network service (depend on Radio,
e.g. Radio support LTE as Highest priority network).
Fast Blinking (500ms duration) Register to Non-Highest priority network service (depend on
Radio, e.g. Radio support LTE as Highest priority network, then
WCDMA and GPRS is non-highest priority network).
Off Register failed
USR: SIM
Green On Router is trying cellular connection with SIM1
Fast Blinking (250ms duration) Router is trying cellular connection with SIM2
Off No SIM detected
Blinking Wi-Fi is enabled and data transmission
Off Wi-Fi is disable or initialize failed
Signal Strength Indicator Green On, 3 LED light up Signal strength (21-31) is high
On, 2 LED light up Signal strength (11-20) is medium
On, 1 LED light up Signal strength (1-10) is low
Off No signal
PIN DEFINITION OF TERMINAL BLOCK
PIN RS232 RS485 POWER INPUT DIRECTION
1 -- -- VIN+ Positive (Red Line)
2 -- -- VIN- Negative (Yellow Line)
3 GND -- -- --
4 TXD -- -- Router --> Device
5 RXD -- -- Router <-- Device
6 -- A -- Router <--> Device
7 -- B -- Router <--> Device
INSERT / REMOVE SIM CARD
• Make sure the power is disconnected.
• Use a Phillips-head screwdriver to remove SIM slot cover.
• Insert the SIM card(s) in to the SIM sockets.
• Replace the SIM slot cover.
INSTALL ANTENNA
Connect the cellular antenna to the MAIN and AUX connector on the unit.
VIN+
VIN-
GND
TXD
RXD
A
B