20. Air compressor central lock (programmable)
Some cars that are equipped with air compressor central lock, such as Benz, Audi and
VW etc. need a little longer signal for central locking system. This alarm cut off red loop
or remove one jumper can become long signal for lock.
21. Two pulse unlock (programmable)
22. Auxiliary 1st output (-) for trunk opening or remote engine start
Auxiliary 1st output (-) (2nd channel output) send 500mA ground signal to remote engine
starter through pink wire.
23. Special anti-car jacking by switch
This system offer a special anti-car jacking for some country that people needs it. If
driver press an optional toggle switch when car ignition is on and car door is opened and
closed again, this system will come into anti-car jacking mode. 1 minute later, siren chirps
per 2 seconds for 10 chirps (20 seconds), then siren blow, parking light flashes, starter killer
(ignition killer) on until ignition off. At that time, the siren and parking lights off, but
starter killer (ignition killer) still works, only over-ride valet switch can over-ride it.
24. Over-ride switch
4
Functions of the over-ride switch
A. Ignition on, press over-ride switch to over-ride alarm when in arming.
B. Ignition on, keep pressing 5 seconds to enter code learning mode.
C. Ignition on to press over-ride to reset special hi-jacking.
D.
Ignition on, press 5 times to enter valet mode.
25. Parking lights relay built-in
How to use the “Code Learning”
a.
Ignition on , press over-ride switch 5 seconds until siren chirps 5 Times, Parking lights
on means system in Code Learning mode.
b.
Press any button of new transmitter for learning, Siren chirps 2 Time means waiting
for 2nd new transmitter to learn.
c.
Press any button of 2nd new transmitter for learning, Siren chirps 3 Time means
waiting for 3rd new transmitter to learn.
d.
Same procedure maximum up to 4 transmitters.
e.
If within 10 seconds no new transmitter‘s signal send out for learning, System turn to
normal state.
f.
Every time learning new transmitter, Former code(old transmitter)will be erased, Hence
old transmitter must also learn again When new transmitter need to learning.
