FUSE
180A
Ground
Remote turn on
Main Battery
12V
Headunit
+12V, GND, REM CONNECTION DIAGRAM
For safety purposes, install the amplifier in a dry and well ventilated location and
make sure no cables or other harness of the car is interfaced with the mounting location or
will present a hazard to the cars' cable, control cables, fuel lines/tanks, hydraulic lines or other
components of the vechicle.
4-3. +12V, GND, REM CONNECTION
12V ( POWER CONNECTION )
Before mounting
B2
amplifiers, disconnect the negative ( ) wire from the battery to protect
any accidentIal damage to the amplifier or the audio system.
B2
series are designed to use 0 AWG power and Ground connection.
Connect the power cables to power terminal labeled as + 12V
Quattro
is equipped with Fuses. But if you want to use external fuses, then connect one end of
the fuse holder to the power cable and the other end of the fuse holder to positive battery
within 20 cm of the same cable.
This fuse location will protect the system and the vehicle against the possibility of a short circuit
in the power cable. Be sure to use fuses and a fuse holder adequate for the application
GND ( GROUND CONNECTION )
Locate a secure grounding connection as close to the amplifier as possible.
Make sure the location is clean and provides a direct electrical connection to the frame
of the vehicle. Connect one end of a short piece of the same size cable as the power cable
to the grounding point. Run one end of the cable to the grounding point.
Run the other end of the cable to the mounting location.
Connect the ground cable to the screw terminal labeled as GND.
REM ( REMOTE CONNECTION )
Run a remote turn on cable from the sw 12V source.
This may be a toggle switch, a relay, or your source unit's remote trigger cables, or power antenna
trigger cable.
Connect the remote turn on cable to the power terminal labeled as REM.
4
