INPUT
Signal input from the head unit. A minimum level
input of 0.2V is essential for correct operation.
POWER & PROTECTION INDICATOR
Power LED, Blue-lit shows correct operation.
Protect LED, Red-lit shows general malfunction,
faulty connection or thermal protection.
GAIN (6V ~ 0.2V)
Matching of the output voltage from the head unit’s
RCA line-outs to the input section.
SUBSONIC FILTER (10Hz ~ 50Hz @ 24dB/Oct)
Adjusts the subsonic cut off point to eliminate
frequencies within the filter’s range.
REMOTE LEVEL CONTROL PORT
Connection of external level control.
(The
Better Bass Remote
can be connected for additional features).
OUTPUT MASTER / INPUT SLAVE
For daisy chain connection of 2
Zero1
amplifiers.
Minimum impedance is 2 .
Output signal can be routed from 1 master amplifier
to 2 slave amplifiers, by setting the switch to SLAVE1
& SLAVE2 on the amplifiers in question.
DO NOT USE IN DAISY CHAIN MODE!
LOW PASS FILTER (35Hz ~ 250Hz @ 24dB/Oct)
Adjusts the cut off point for the low pass filter
within the filter’s range.
PHASE CONTROL
Variable phase adjustment from 0-180 degrees.
4
2. Panel layout
BASS BOOST
Variable bass boost with 0-9dB.
BASS FREQ
Variable bass boost frequency from 30Hz ~ 80Hz
SPEAKER OUTPUTS
Amplifier connection to the loudspeakers.
Minimum speaker cable is 12 gauge.
Minimum impedance for the
Zero1
is 1 if
used as a single unit.
In a daisy chain configuration the minimum
impedance is 2 .
Zero1
BASS
BOOST
0dB 9dB
BASS
FREQ
30Hz 80Hz
MASTER
SLAVE1
SLAVE2
SWEET LIKE DANISH
Summary of Contents for Zero1
Page 1: ...MODEL Zero1 Product id ZERO1D12 OWNER S MANUAL Zero1...
Page 10: ......
