9
SLD5k
strapped Speaker Wiring Diagram
*
Leave Master unpressed
PROTECT
POWER
REMOTE
BOOST
FREQ.
LPF
PHASE
SUBSONIC
GAIN
BASS
SLAVE
OUTPUT
MASTER
INPUT
SLAVE
INPUT
R
L
0.2V
6V
10Hz
50Hz
0dB
9dB
30Hz
90Hz 35Hz
250Hz
0
180
MASTER
SPEAKER
PROTECT
POWER
REMOTE
BOOST
FREQ.
LPF
PHASE
SUBSONIC
GAIN
BASS
SLAVE
OUTPUT
MASTER
INPUT
SLAVE
INPUT
R
L
0.2V
6V
10Hz
50Hz
0dB
9dB
30Hz
90Hz 35Hz
250Hz
0
180
MASTER
SPEAKER
Speaker Impedance 2~ 16 ohm
Linking or strapping makes 2 amplifiers work as a single amplifier.
This configuration will near double the rated output power.
Follow the instructions carefully as it can cause harm to your system if done incorrect.
Speaker impedance 2 Ohm ~ 16 Ohm
Loads under what is specified will cause excessive heat & the amplifier
will reach thermal at a faster rate & will eventually go into protect.
Strapped impedance load under 2 ohm is not warranted!
slave
To link the master and slave amplifier speaker connection follow the steps below.
step 1.
Run the
positive (+)
speaker cable from the
master
amplifier’s speaker output to the
positive terminal (+)
of the subwoofer.
step 2.
Run the
positive (+)
speaker cable from the
slave
amplifier’s speaker output to the
negative terminal (-)
of the subwoofer.
Step 3.
Connect both amplifiers together by running a cable from
negative
speaker output on
master
amplifier
to
negative
speaker output on
slave
amplifier. Use minimum 8 GA cable for connecting the amplifiers.
*Press the switch on the slave for
strapped mode
master