Section 1 - Quick Start Guide
Cable Conversion Guide
Step 1.
Connect the Positive (Red) and Negative (Black) cables to the battery, ensuring you are using
cable that is of adequate size for the demands of the system, and well crimped and protected
termination lugs.
Example;
1000W Inverter - at least Gauge 2 (35mm²)
2000W Inverter - at least Guage 00 (70mm²)
The spring washers must be used on the battery terminal bolts - they apply pressure to the lugs for a
secure connection. There is no need to over-tighten the bolts, simply ensure there is no movement of the
cables. Make sure the main Battery Cable lug is mounted directly onto the Battery terminal with no
washers between them.
Step 2.
Your charger/s need to be programmed for Lithium, with a charging voltage of 14.0 -14.6 Volts
and Float 13.5 - 13.6 Volts.
Do not use a lead-acid charger if you want the best out of your battery. These chargers can damage the
battery if left connected and will void your warranty.
Step 3.
Fully charge the battery and it is ready for use.
*Note: The above is a “Quick Start” guide, detailed information follows.
Page 4
Enerdrive B-TEC G2 Manual (Rev. 2.1)
