B.Pro TS-H1, Translation Of The Original Operating Instructions

Page: 20 / 52

20
Mobile Plate Dispenser OPERATING INSTRUCTIONS
L Individual springs are hooked and unhooked to adjust the distribution height of stacked
items.
L The unit is supplied from the factory with fully hooked springs.
)
The following always applies to setting the distribution height of stacked items:
– The springs must be unhooked and hooked in symmetrically.
– The springs must be unhooked from the inside outward; i.e. start with the central spring
when unhooking the springs.
– The number of springs hooked into both setting sides may differ by a maximum of 1
spring.
Caution!
Sharp spring end.
The sharp start of the spring can cause injuries to arms, hands and fingers if fitted incorrectly.
–
When fitting the springs, you must ensure that the start of the spring on both sides does not
point to the centre of the well.
)
If a different type of stacked item is to be stacked at a later time and it is necessary to change
the distribution height of stacked items, either unhooked springs must be hooked in or additi-
onal springs unhooked.
– Ensure that the unit interior has cooled down.
– Completely remove the stacked items.
– On the lower attachment section, hook in o unhook one of the inside springs at each of the
two opposite setting sides.
–
Test distribution height of stacked items and hook in or unhook additional springs if necessa-
ry.
Setting the distribution
height of stacked items