B.M.P. ThermicRoll, Installation Manual, Page: 19 / 38

Installation Instructions
JAMISON DOOR COMPANY 19
H4494002 REV B
10.
MOTOR ROTATION
Jog open button (P1)
Programming button (P2)
Jog close button (P3)
To reverse rotation swap terminals 23
and 24 on the controller board
23
2
4
2
5
Any electrical work must be done by qualifed and
knowledgeable personnel, serious injury or death could
result if work is done by unqualifed personnel
.
•
See wiring diagram for location for landing power and ground.
•
Before connecting power to the control panel check the control transformer setting to be sure it is set
for the line voltage you will be using, if it is wrong correct it by moving the wire to the appropraite
voltage. If this is incorrect also check the motor wiring to be sure it is correct, see Section 19.
•
Jog the door closed using P3, if the door rotates in the wrong direction correct the motor rotation by
reversing the wires on terminals 23 and 24 at the center-right of the control board.
•
Once the motor rotation is corrected, use P3 to jog the door to the fully closed position. The jog
buttons may only move the door a few feet even if they are held so you will likely have to push and
hold them more than once to get the door fully closed.