Union Bollard
Installation Instructions
1. Remove 1/4-20 nuts from installed Union
anchor kit with a socket. Keep the hardware
to reuse in the next step.
2. Line up then place base over installed 1/4-20
nuts.
3. Secure to anchor bolts with the 1/4-20 nuts
and lockwashers provided with the Union
anchor kit using a socket.
Base & Tenon Installation
4.
Seal as per NEC with waterproof silicone
sealant (not included).
If the fixture has a receptacle.
7. Secure receptacle cover by tightening #6-32
set screw using a 7/64” allen wrench.
6. Attach receptacle to installed anchor base with
four (4) #10-32 stainless steel countersunk
screws at the base using a 1/8” allen wrench.
5.
Pull primary branch circuit wiring and any
additional dimming controls or other wiring
necessary for installation. Attach ground from
branch circuit to ground lead on the anchor
base. Place connectors inside of the housing
(Please refer to page 4 for wiring diagram).
RELEASED DATE
02/22/2022
REFERENCE NUMBER
INS-2846-00
40429 Brickyard Drive • Madera, CA 93636 • USA
559.438.5800 • FAX 559.438.5900
www.bklighting.com • [email protected]
B-K LIGHTING
IMPORTANT SAFETY INFORMATION LISTED ON REVERSE
READ, FOLLOW, AND SAVE ALL SAFETY AND INSTALLATION INSTRUCTIONS
