RELEASED
6-30-19
REFERENCE
NUMBER
INS-2810-00
40429 Brickyard Drive • Madera, CA 93636 • USA
559.438.5800 • FAX 559.438.5900
www.bklighting.com • [email protected]
B-K LIGHTING
IMPORTANT SAFETY INFORMATION LISTED ON REVERSE
READ, FOLLOW, AND SAVE ALL SAFETY AND INSTALLATION INSTRUCTIONS
THIS DOCUMENT CONTAINS PROPRIETARY INFORMATION OF B-K LIGHTING, INC. AND ITS RECEIPT OR POSSESSION DOES NOT CONVEY ANY RIGHTS TO REPRODUCE, DISCLOSE ITS CONTENTS, OR TO MANUFACTURE, USE OR SELL ANYTHING
IT MAY DESCRIBE. REPRODUCTION, DISCLOSURE OR USE WITHOUT SPECIFIC WRITTEN AUTHORIZATION OF B-K LIGHTING, INC. IS STRICTLY FORBIDDEN.
Fixture Installation
2.
Place tree ring fixture around tree.
Move fixture to desired height. Tighten
the entire assembly to the tree with
provided stand-offs.
3. Secure by hooking end of strap over two (2)
Phillips screws. Secure by tightening two (2)
Phillips screws with Phillips screwdriver.
5. Bring line voltage cable from power line to
main splice box location. Loosen cord grip on
bottom of splice box, feed line voltage cable
from power line through, then tighten cord grip
to secure
5. Remove top of driver housing by removing (4)
#8-32 set screws using 5/64” Allen wrench.
Driver housing will be marked for primary.
WIRING DIAGRAM
7. Make watertight connections from primary
branch circuit to driver with waterproof wire
connectors. (By Others). Fixtures are pre-wired
at factory on the secondary side.
See wiring
diagram.
120V
LED
COM
GROUND
Driver
GROUND IN HOUSING
Factory
Wired
8. Replace top of driver housing with (4) #8-32
screws with 5/64” Allen wrench.
4. Connect secondary cable then twist to secure
in place.
PALM TREE RING INTEGRAL
ArtiStar™ Series
Standard Installation
