MAN
62
88
– 0
3120
9–4
notice:
Commercially available stairway-lighting timer-
switches differentiate according to the type and
manner in which the neon glow-lamp push button
is energized.
There are models available with integrated half-
wave or full-wave rectification.
As the
LUXOMAT
®
Indoor 180-SC uses the result-
ing neon glow-lamp supply to power itself, this
determines the current consumption and thus the
max. possible number of the
LUXOMAT
®
Indoor
180-SC’s.
Caution:
Full-wave rectification leads to greater dissipation
power-loss and thus to the
LUXOMAT
®
Indoor
180-SC becoming heated-up.
The following list does not claim to be complete.
The models listed are only given as examples:
Stairway lighting-timer
U-button
Indoor 180-SC
HAGER EM001N
50 Hz
ca. 4 mA
–> ca. 20 x Indoor180-SC
EBERLE ITZ50
100 Hz
ca. 8 mA
–> ca. 4 x Indoor180-SC
attention:
For technical reasons, we recommend the
use of above-mentioned staircase lighting automates.
7. Electromagnetic compatibility
It cannot be excluded that spurious triggering can
be caused when placed directly in the area of
strong radio transmitters (e.g. radio operators, taxi
control centres, cell phones etc.).
However, these phenomena do not cause any
defects in the sensor technology. If such spurious
triggering does occur, the
LUXOMAT
®
Indoor
180-SC automatically switches off after the source
of HF interference has disappeared.
8. Detection area
9. Trouble shooting - Practical hints
1. Lamp does not light up
- Tungsten halogen lamp defective
Replace tungsten halogen lamp
- No mains connection
Check connection by qualified electrician
- Incorrect setting of lux level
Correct setting of lux level
- Unit mounted too high
Mount at recommended height
- PIR detector lens obstructed by dirt or other
objects
Clean lens or remove objects
- Main fuse defective
Check or replace by qualified electrician
2. Delayed lamp activation
- Mounted too high
Mount at height stated in specification
(
1.10 - 2.20 m
)
- Direct line of approach
Re-direct walking so that the approach is not
frontally
3. Lamp stays on continuously
- Continual thermal activity detected ie. extractor
fan, central heating ducts
Check for any activity which could cause unit
detection to be maintained
- Delay time set too high
Reduce time delay
Check ambient noiselevel, if necessary switch off
noisesources
4. Limitation of range
(not up to the minimum specification)
- Mounted too high
Correct mounting height
- Temperature difference between ambient tem-
perature and source of heat too small
No improvement possible
- Direction of movement aimed directly at lens of
motion detector
Move laterally to detector
• Settings of the operating time and twilight value.
• Mount covering-cap
(F)
.
• The covering-cap
(F)
can be removed as shown
in the drawing.
For outdoorinstallations additionally the IP54-acces-
sory- fixing-set has to be mounted (Part nr. 92139).
4. Adjustment - Rotary control
4.1 Twilight threshold value:
The lighting actuator value can be preset
between 5 and 2000 Lux
Night setting
Day/night operation
4.2 Suppressing the twilight threshold-value query
The suppression time can be set from
ca. 1min. to 10 min.
5. Wiring diagrams:
6. Technical data
• Operating voltage via the stairway lighting-
timer 230 VAC
• Power consumption ca. 4 mA /230 VAC
• Impulse duration
0.1 sec.
• Impulse switching capacity
max. 200 mA /230 VAC
• Detection area
180° horizontal
ca. 60° vertical
• Detection range at 1,10 - 2,20 m installation
height:
max 10 m during sideways passing
ca 3 m during direct approach
• Twilight threshold value
ca. 5 - 2000 Lux
• Twilight threshold-value suppression
ca. 1min. - 10 min.
• Dimensions L x W 87 x 87mm
Installation depth 36 mm
• Protection
IP20, II
(with accessory IP54)
• Housing
UV- and shock-resistant
Polycarbonate
Detection area Indoor 180
Side view
Top view
Walking across
Walking towards
3 m
Erfassungsbereich Indoor 180
Montagehöhe 1,1 - 2,2 m Seitenansicht
8 m
3 m
Aufsicht
Gehen quer zur Erfassungsrichtung
frontales Gehen
3 m
Mounting height 1.10 - 2.20 m
10 m
3 m
4.1
4.2
LED
C
A2 B
a1 4
L
n
indoor180-SC
f. ex.: 4-wire-system
recommendation
max. 10 Indoor180-SC
indoor180-SC
F
D
F
D
