B DUTCH RVS BD700.000010, Installation Manual

Page: 3 / 8

3
ENGLISH
With the correct installation and use, the B DUTCH stainless steel taps last for many decades. The B DUTCH
stainless steel taps have an interior with a ceramic seal. This interior is of top quality and ensures a long
lifespan of the crane, but this interior cannot withstand dirt. Dirt prevents the tap from closing properly and the
spout leaks. Therefore, always flush the pipes well before installing the built-in part so that all dirt is removed
from the pipes. Open the tap and let the water run through and flush and then mount the tap. This prevents dirt
from getting between the discs. To prevent dirt from entering, always keep the white plastic protective cap on
the built-in part during assembly.
If dirt has entered the interior with a faulty faucet as a result, there is no other option than to replace the
cartridge. The cartouche forms one whole and cannot be opened.
The built-in part of the B DUTCH faucets can only be installed correctly. So pay close attention to the top.
All rosettes from B DUTCH also include a rosette, a suitable stainless steel cover ring. When plastering and
tiling, you must take into account that this stainless steel cover ring only covers 7.5 mm compared to the
plastic protective cover of the built-in part. So there must be tight plaster or tiled around the built-in part! A
larger cover ring does not match the minimalist design of our stainless steel taps.
Attention - Before Installation
1. Inspect this product to ensure you have all parts as shown that are required for proper installation.
2. The valve cartridge has been factory tested and adjusted – DO NOT TAKE THE CARTRIDGE
APART. Taking the cartridge apart will void the warranty.
3. Ensure that both hot and cold water feeds are properly connected to the marked lav connecting.
4. This product must be installed by a professional contractor.
5. Refer to the specification and assembly drawings attached for installation directions.
6. Flow Pressure – Min. 25 PSI, Max. 80 PSI. Recommended pressure – 50 to 60 PSI.
Installation Requirements
Please read the instructions carefully so as to avoid any damage to the fixture.
1. To ensure this product is installed properly, you must read and follow these guidelines.
2. The owner/user of the faucet must keep this information for future reference.
3. Be sure your installation conforms to local codes.
4. Refer to the specification and assembly drawings attached. Faucet is sold partially assembled but
shown fully disassembled for illustrative and service purposes only.
5. Inspect this product to ensure you have all parts required for proper installation.
6. Use only a strap wrench or protected/smooth- jaw wrench on any finished surface.
7. If possible, install the faucet assembly on the sink or mounting surface before setting.
8. Do NOT use putty during this installation.