This is how I do it.
I’ve taken an ordinary scissors
and rounded off the ends.
After tracing the
FEC onto the
INSIDE bottom of a
Can bottom that
I’ve cut off, (page
6), I “slowly” cut
away the Can.
The trick is not to
try and cut the
thing out in one
pass. Just cut a
little at a time.
Then trim as
needed.
1
2
3
4
5
6
7
8
Once you have
the outside
dimension, put a
hole in the
center. I just use
my awl (sharp-
ened screw-
driver) or you
could “drill” a
hole also.
Next I use a small manicure scissors
and “gently” cut out the center.
Again, don’t try and do it all in
one pass. Cut a little out at a time.
Once I have it
pretty much
the way I
want it, I use
a “rat-tail-
file” to
smooth out
the edges.
