Thread the connector and lead wire through air
hole and hole at the middle of the preamp, keeping
the preamp at the side of the shell. Bring enough
of the lead wire out so that it can be inserted to the
side slot of the bolt.
Note!
The connector of the mic will not fit through
the hole of the bolt. the bolt has a slot along the
side. Slide the mic lead wire sideways into the slot
at the side of the bolt.
11. Insert bolt through the hole of the preamp and
shell. Screw and tighten the nut to the bolt. Be
careful not to damage the lead wire.
12. Connect mic to preamp to the pin connector
that is angled and pointing down with the holes at
the mic connector facing out.
13. Set tone controls (mini switches -
see page 14).
