B+B SmartWorx Wzzard WSD2C31010, User Manual, Page: 16 / 44

Wzzard
™
Sensor Edge Nodes
16
3) Sensor Level
Expand the tree to see individual sensor I/O by clicking on the triangle next to the node.
When an individual sensor is selected, you can configure all parameters for that endpoint.
Enable/Disable, change between a voltage input and 4-20mA current, change scaling reported to real
Engineering units, change temperature reported between Centigrade and Fahrenheit, etc.
CREATE AND LOCK THE NETWORK
1) Wake Up The Node
Press and hold Status/Sleep/Reset configuration button for 5 seconds until the Status LED comes on and
starts blinking.
2) Check LEDs
After you wake the node, the Status LED will begin to blink. This indicates that the node is attempting to
establish a network connection. The Status LED will come on solid when a network connection is made.
Note: The Status LED goes off after 10 seconds to conserve battery life. To check status, use a short press of the
Status/Sleep/Reset configuration button.