SmartFlex SR300
5.8.4
MicroSD card reader
The microSD card reader is placed on the rear panel of the router (there is only a single
slot). This card reader allows the router to operate with memory cards microSD. Technical
specifications are stated in the table below.
Technical specifications of microSD card
Supported technologies
SDHC, SDXC
Supported capacity
SDHC
SDXC
up to 32 GB
from 32 GB to 64 GB
Supported microSD card filesystems
vfat, ext2, ext3, ext4*
Table 11: Technical specifications of microSD card
* Supported only with
Ext4_tools
User Module installed in the router.
Changing the microSD card:
•
Use the flat end of a spudger, or your fingernail, to press the microSD card slightly
deeper into its slot until you hear a click.
•
After the click, release the card and it will pop out of its slot.
•
Remove the microSD card and push any other microSD card into the slot until it
clicks in place.
Figure 14: MicroSD card
Mounting microSD card to the system:
To use the microSD card in the Linux system of the
router, it is necessary to mount it. Use
dmesg
command to see the name of recently connected
device (E. g.
mmcblk0:
p1
) and then use
mount
command. Example:
mount /dev/mmcblk0p1 /mnt
16
