The U601BS Mainboard User Manual
Page 23
2.8.7. VGA Connector
Jumpers are built on the mainboard to allow the user flexibility to configure
the mainboard settings to meet their specific requirements. The
U601BS
mainboard has a single three pin jumper. On a three pin jumper if a jumper
cap is inserted on pins 1 and 2 we say
PIN 1
and
PIN 2
are
SHORT
. When
the jumper cap is inserted on pin 2 and 3, we say
PIN 2
and
PIN 3
are
SHORT
(see the diagrams below).
If you have made an improper setting in the BIOS setup and your computer is
not functioning, or if you have forgotten your password, you can use this
jumper, JP 1, to clear the CMOS memory and to reconfigure your system.
To clear the CMOS, please follow these instructions:
1.
Turn the system power “OFF” and unplug your computer.
2.
Insert the jumper cap on Pin 2 and Pin 3 for 3 ~ 5 seconds.
3.
Pull out the jumper cap and replace it on Pin 1 and Pin 2.
4.
Turn your PC on and run the BIOS setup program.
SHORT PIN 1/PIN 2 PIN2/PIN 3
PIN: 1 2 3
PIN: 1 2 3
Three Pin Jumpers
Hardware Installation
Connector: CN 19
Type: 15 pin male.
Connect your VGA monitor adapter to this con-
nector.
2.9. Clear CMOS Memory
JP: Clear CMOS
PIN: 1 2 3