PT-5IV
SYSTEM BOARD
AWARD BIOS SETUP
5.10 LOAD SETUP DEFAULTS
This option loads the SETUP default values from BIOS default table. By pressing "Enter" key, while "LOAD
SETUP DEFAULTS" is highlighted, then presses "Y" and "Enter" key. the SETUP default values will be
loaded. The SETUP default settings are the best-case values that should optimize system performance and
increase system stability. If CMOS RAM is corrupted, the SETUP DEFAULTS settings are loaded
automatically.
5.11 SUPERVISOR PASSWORD / USER PASSWORD
Type the Password and press "Enter",then repeat. Enters up to eight alphanumeric characters.
By pressing "Enter" key twice, without any alphanumeric character enters, the PASSWORD will be disabled.
5.12 IDE HDD AUTO DETECTION
By pressing "Enter" key, while "IDE HDD AUTO DETECTION" is highlighted causes the system to attempt to
detect the type of hard disk. If successful, then presses "Y" (or 1, 2, ...) and "Enter" key, it fills in the remaining
fields on this menu and the correlated fields in the STANDARD CMOS SETUP menu.
5.13 HDD LOW LEVEL FORMAT
This option provides an utility program for IDE HDD Low Level Format. Performing the Hard Disk Format
will destory any data on the Hard Disk. Back up the Hard Disk(s) before actually performing of these routines.
Note : These routines are not valid for a
SCSI
Disk Drive.
5.14 SAVE & EXIT SETUP
This option saves all setup values to CMOS RAM & EXIT SETUP routine, by moving the cursor to "SAVE &
EXIT SETUP" and pressing "Enter" key, then types "Y" and "Enter" key, the values will be saved, the setup
program will be terminated and the system will be reboot.
5.15 EXIT WITHOUT SAVING
This option exites setup routine without saving any changed values to CMOS RAM, by moving the cursor to
"EXIT WITHOUT SAVING" and pressing "Enter" key, then types "Y" and "Enter" key, the setup program will
be terminated and the system will be reboot.
5-10
