AzureWave AW-AM691NF, User Manual, Page: 38 / 45

- 38 -
3. Download mini driver (see 3.1)
4. In the “HCI Control” window, select “7.3 Host Controller & Baseband Commands” (Note: may be 4.3,
depending on version)
5. Double Click the “Write Scan Enable” entry
6. Select “Inquiry and Page Scan Enabled” and click “OK”
7. Double Click “Set Event Filter”
8. Select “Connection Setup”
9. Select “Allow Connections from all devices”
10. Select “Do Auto accept the connection with role switch disabled”
11. Click “OK”
12. In the “HCI Control” window, select “0 Vendor-specific commands”.
13. Double Click the “Write_BD_ADDR” command
14. Enter 001122334455
15. In the “HCI Control” window, select”0 Vendor-specific commands”. Double Click”Update UART Baud
Rate”. Select 3000000 then click OK.
SET UP THE MASTER DEVICE, AND CREATE THE CONNECTION
1. On the
Master
side, start Bluetool.
2. Open the log window, if not already open, and open the UART HCI Transport.
3. Download mini driver (see 3.1)
4. In the “HCI Control” window, select “7.1 Link Control Commands” (Note: may be 4.5 depending on
version)
5. Double Click “Create Connection” and put BD address of the slave device into the BDADDR box.
Click “OK”
6. In the “HCI Control” window,select”0 Vendor-specific commands”. Double Click ”Update UART Baud
Rate”. Select 3000000 then click OK.
A connection should establish now. This can be verified by looking in the log windows for both devices,
which should now contain Connection Complete events with “Success” in the status field.
NOTE: once the connection has been established, Inquiry and Page Scan can be disabled. Also, go to: “7.3
Host Controller !"$'*;<'>?"@QYY'>?*Z"\\"^`;{"|};>{"~€{;Z‚" " `;€;ƒ{"^@Q>>;ƒ{Q>"`;{„ Z†"`;€;ƒ{"^‡€€Qˆ"