English
5
Quick Start Guide
1.
Press any button
to wakeup the gauge. If LCD does not light up, check battery
pre-installed on the back. (Gauge will wakeup automatically when sense pressure from tire or
compressor.)
2.
Testing LED lighting by holding left button
for 3 sec, hold another 3 sec to turn it off.
3.
Press
button to switch between 4 units, Psi, Bar, Kgf/cm2, Kpa.
4.
Select M-Type or Q-Type air fitting according to your air compressor. M-type is also known as “US
Standard Fitting”, which is most commonly found in US, Q-Type is also known as “Japanese
Standard Fitting”.
5.
Use Thread Seal Tape Roll properly seal air fitting before install on the gauge. Ignore this step
when connect gauge directly to 1/4 NPT compressor hose.
CAUTION
: Do NOT over-tighten air fitting, could result in product damage.
6.
Connect the gauge to air compressor from air fitting end, and clamp Brass Air Chuck to tire valve.
Push Thumb Trigger to add air, push Air Bleeder to lose air.
CAUTION
: Accurate measurement should read while Thumb Trigger and Air
Bleeder in default position. Do NOT read during inflation or deflation.
7.
(ATG200A01)
Switch pre-installed Brass Air Chuck to “
AirTight-Twin-Valve
” if inflating
Presta/Schrader valve bike tire. After push “Twin Valve” till end of Presta/Schrader valve on the
tire, push lever to left end for Presta and right end for Schrader valve.
Summary of Contents for ATG200A01
Page 1: ...ATG200A01 ATG200B01 ...
Page 2: ...English 2 English Original Instructions ...
Page 3: ...English 3 ...
