FORM S2-S2H200-1 AZTEC CARPET/HARD FLOOR EXTRACTOR (10-25-02) - 5
PREPARING FOR USE AND OPERATING THE MACHINE
SPOTTING PROCEDURES PRIOR TO OPERATING MACHINE
1
Soak up excess liquids with a towel.
2
Test cleaner on a small inconspicuous area to make sure it will not damage the carpet fibers.
3
Apply appropriate spotter, follow directions on bottle.
4
Start at outside edges of stain and work toward the center. Use a dabbing, not a rubbing action.
5
Repeat steps 3-4 if needed.
OPERATING THE MACHINE
WARNING!
Use only
nonflammable commercial chemicals intended
for machine application.
1
UNPLUG machine before attempting to fill with water and position switch to the middle "OFF" position.
2
Pour 1-1/2 gallons of the warmest water possible to shorten heating time.
BE SURE TO FILL WATER TO THE LID EDGE! It will not heat unless entirely full.
3
Toggle the power switch to "HEAT". The amber light will come on indicating the heating cycle has begun.
4
When water temperature reaches maximum degree of heat, the green light will indicate machine is ready for use.
5
Toggle the power switch to "Vacuum".
6
Release water from nozzle until hot water transfers through the length of vacuum hose. Remember, the remaining
water in the hose will be cold.
CAUTION!
Do not continue to use the machine after the Recovery Tank is FULL. This will damage the vacuum motor and is NOT
COVERED UNDER WARRANTY.
HOT WATER
AFTER USE
WARNING!
To reduce the risk electric shock or injury, unplug the power cord before servicing.
1
Toggle the Power Switch to the MIDDLE position to turn both the vacuum motor and the solution pump OFF.
2
DISCONNECT THE POWER CORD.
3
Move the machine to a designated waste water “DISPOSAL SITE”.
4
Disconnect the Hose Assembly from the machine.
5
Tip the Recovery Tank and drain through hose connection port.
6
Tip the Solution Tank and drain unused water or solution. Rinse the tank thoroughly if any cleaning chemical was used.
BE AWARE / WATER TEMPERATURE
MAY EXCEED 200°F.
USE CAUTION WHEN USING THIS MACHINE.
