GROUNDING INSTRUCTIONS
THIS PRODUCT MUST BE GROUNDED
WHILE IN USE TO PROTECT THE
OPERATOR FROM ELECTRICAL SHOCK.
This product is equipped with a power cord that
has a grounding conductor and a grounding
plug. The plug MUST be plugged into a
matching electrical receptacle that is properly
installed and grounded in accordance with ALL
local codes and ordinances.
DO NOT MODIFY THE PLUG PROVIDED.
USE ONLY A 3-WIRE EXTENSION CORD
THAT HAS A 3-PRONG GROUNDING PLUG
AND A 3-POLE RECEPTACLE THAT
ACCEPTS THE POWER SUPPLY CORD'S
PLUG. REPLACE A DAMAGED OR WORN
CORD IMMEDIATELY.
Improper electrical connection of the equipment-
grounding conductor can result in risk of
electrical shock. The conductor with green
insulation (with or without yellow stripes) is the
equipment grounding conductor.
Check with a qualified electrician or service
personnel if you do not completely understand
the grounding instructions, or if you are not sure
the equipment is properly grounded.
This product is intended for use on a circuit that
has an electrical receptacle with a grounding
conductor as shown in Figure 1. If a properly
grounded electrical receptacle is not available, an
adapter (see Figure 2) can be used to temporarily
connect this plug to a 2-contact ungrounded
receptacle. The adapter has a rigid lug extending
from it that MUST be connected to a permanent
earth ground, such as a properly grounded
receptacle box. THIS ADAPTER IS PROHIBITED
IN CANADA.
RECEIVING THE EQUIPMENT
When unpacking, inspect the large shipping
carton. It should contain the following items:
• 1 Applicator base unit
• 1 Lift handle assembly
• 1 Empty pail
• 1 Suction hose assembly
• 1 Battery pack
• 1 Small parts package (lift handle, lift pins,
distribution tube end caps and paper clips)
• 1 Power cord
Inspect the small shipping carton. It should
contain a cleaning tray, a head assembly, an
applicator pad, and a head cover.
ASSEMBLY
1. Attach the head assembly and the pad holder
to the front of the Grand Finale.
2. Insert the lift handle through the lift handle
guide and over the transport bracket, then
attach the lift handle to the head assembly.
Secure the lift handle to the head assembly
with pin.
3. Connect feed hose to head assembly and
suction line to front panel.
PG. 2 GRAND FINALE
GRAND FINALE PG. 7
WARNING
!
DANGER
!
GRAND FINALE HEAD ASSEMBLY PARTS LIST
# PART #
DESCRIPTION
QTY
1 283-050-210
Drip Tray
1
2 050-440
36" Head Cover
1
3 050-450
36" Applicator Pad
1
4 288-050-100
36" Pad Holder Assembly
1
5 288-050-115
36" Manifold Housing Assembly
1
6 625-32854440
Spring Latch Pin
2
7 050-200
Applicator Spacer
4
8 050-350
Manifold Mounting Clip
2
9 283-050-130
36" Manifold
1
10 050-100
Manifold Tube Caps
2
11 050-310
Hose Clamp (Nylon)
2
12 216-0609
3/8 x 9/16 Clear Tubing
1
13 050-280
Quick Coupling Insert
1
