902-762 Four Panel Circular Aztec Climber
Designed for Ages 5-12
Page
5
Rev. 04/9/2010
SportsPlay Equipment, Inc., 5642 Natural Bridge, St. Louis, MO 63120 (314) 389-4140
www.sportsplayinc.com
GENERAL MAINTENANCE INSTRUCTIONS:
Check MONTHLY for loose bolts, damaged or broken parts. Tighten and/or
replace immediately. Replace any parts that show a reduction of 25%
from the original size.
GENERAL ASSEMBLY INSTRUCTIONS:
Check all the parts and hardware with the packing list to be sure you
have received everything needed to assemble this product. CONTACT YOUR
LOCAL DISTRIBUTOR WITH NOTIFICATION OF ANY MISSING OR DAMAGED PARTS.
Contact must be made within ten days of receipt of your order.
Only hand-tighten nuts & bolts on initial assembly. Final tightening
should be done EVENLY after final assembly when unit has been plumbed &
leveled.
After assembly is complete, ANY ENDS OF BOLTS PROTRUDING BEYOND NUTS
SHOULD BE CUT OFF AND/OR PEENED OVER TO REMOVE ANY SHARP EDGES. Go
over entire unit to file smooth any sharp edges or projections that may
have been caused by rough handling in shipping or installation.
ASSEMBLY AND INSTALLATION:
NOTE:
All threaded ends of bolts protruding beyond nuts must be cut off
and/or peened to eliminate sharp edges. No more than two threads
should extend beyond face of nut. All washers, “T” nuts, and
other fastener hardware used on round pipe or tubing must be
hammered down to conform to the curved underlying surface to
eliminate catch points. All Bolts must be covered with Bolt Caps
and Covers
STEP #1: Using Footing Diagram as a guide, mark and dig footing holes.
Footing holes are to be 1’-6” deep x 1’-6” in diameter, depending
upon amount of resilient safety surfacing used, local climate and
soil structure, and topography of land. The hole should then be
filled with dry concrete or stone leaving 1’ of the hole open for
the post.
