Aztec Tents Traditional Frame Tent, Install Instructions Manual

Page: 22 / 36

Step 15:
Anchor the tent with the included stakes and ropes. The ropes should be tied
around each of the perimeter fittings with an overhand slip knot. The stakes
should be driven approximately six (6) feet away from the bottom of the leg. To
achieve proper rope tension, drive each stake approximately 24” into the
ground with a sledge hammer. Tie the rope to the stake with a clove hitch and
continue driving the stake into the ground until the rope is taught.
WARNING: The safe installation and use of commercial tenting products can vary from site to site and during varying climactic condi-
tions. Careful consideration should be paid to any installation during windy conditions. Techniques other than those specified above may
be required during these types of conditions.
Soil conditions also vary from site to site. The included anchoring package for this tent may need to be supplemented with alternate
anchoring during windy conditions and in areas with questionable soil holding power. Full product engineering is available, but not
included, by the manufacturer including structural engineering and site specific soil engineering.
Questions pertaining to the proper procedure for the installation of this and any tent product manufactured by Aztec Tents & Events
should be directed to our design staff at (800) 228-3687.
490 Alaska Avenue Torrance, California 90503 Toll Free (800) 228-3687 Fax (310) 381-0722 www.aztectent.com