TURNING ON THE BOARD:
Press the Top Button once to turn
on the board. The upper LED will show a
Red Light (Safe Mode)
and the Lower LED will show a
Green Light (Default setting is
Semi-Auto mode)
. If the Upper LED is flashing
Red
, the battery
has a low charge and needs to be replaced. The Battery power
status can be verified by press the Top Button once more.
SAFE MODE:
After turning on the board, press the Lower Button
once to turn off the Safe Mode. The Upper LED will show a
Green Light
to indicate the Eyes are on. Press the Lower Button
again to turn on the Safe Mode. The Upper LED will revert back to
the
Red Light
to indicate the Safe Mode is on.
EYES ON/OFF:
When the Safety is off and Upper LED will show a
Green Light (Eyes On)
. Pressing the Top Button once will change
the Upper LED to an
Orange Light
indicating that the eyes are off.
To turn the eyes back on, press the Top Button again.
The Upper LED will show a
Green Light
indicating the Eyes are on.
If the Eyes become blocked by paint or the
Delrin Bolt (BA02)
,
the Upper LED will
Flash Green
. Pressing the Top Button twice will
reset the Eyes back to a
Solid Green Light
. If the Upper light
continues to
Flash Green
, clean out the Eyes and check to see
if there is something blocking them.
FIRE MODE LOCK:
To lock the marker in the desired fire mode,
a
Red Circuit Jumper
needs to be removed from the Circuit Board.
The Circuit Board will turn on with the last fire mode used when the
“
Jumper
” is removed. When the jumper is on the Circuit board, the
marker will power on with the default
Green Mode (Semi-Auto)
.
To re-enable all firing modes, simply place the Circuit Jumper back
onto the Circuit Board.
USING THE ZEN BOARD
UPPER LED
RED
= SAFE MODE
GREEN
= EYES ON
ORANGE
= EYES OFF (10.5 BPS)
FLASH RED
= LOW BATTERY POWER STATUS
FLASH GREEN
= EYES MALFUNCTION (8 BPS)
LOWER LED
GREEN
= SEMI-AUTO (20 BPS SS=0)
DARK BLUE
= PSP RAMP (10.5 BPS SS=3)
PURPLE
= SEMI-AUTO (15 BPS SS=0)
LIGHT BLUE
= FULL AUTO (10.5 BPS SS=3)
FLASH GREEN
= PROGRAMMING MODE
LED COLORS
TOP BUTTON
PRESS ONCE = POWER ON
PRESS AGAIN = VERIFY BATTERY POWER STATUS
PRESS AGAIN = EYES ON/OFF
PRESS AND HOLD = TURN OFF
BOTTOM BUTTON
PRESS ONCE = SAFE MODE ON/OFF
PRESS AND HOLD = ENTERS PROGRAMMING MODE
IN PROGRAMMING MODE
PRESS ONCE = CYCLE THROUGH SHOOTING MODES
PRESS AND HOLD = CONFIRM SHOOTING MODES
BUTTONS
NOTE: Safety Shot (SS) defines the number of consecutive trigger
pulls that must be achieved in order to activate the fire mode.
To increase your velocity FPS (Feet Per Second), use the allen
wrench to turn the
Velocity Adjuster (VA01)
clockwise.
To decrease your velocity FPS (Feet Per Second), use the allen
wrench to turn the
Velocity Adjuster (VA01)
counterclockwise.
VELOCITY ADJUSTMENTS
(INCREASE & DECREASE VELOCITY)
COUNTERCLOCKWISE
DECREASE VELOCITY
CLOCKWISE
INCREASE VELOCITY