Page | 25
GAMING KEYPAD
| Manual
(3) If you are using Azeron keypad on consoles through XIM device, then
it is possible to Install XIM optimized firmware, which removes all
unnecessary features, leaving only one profile in the on-board memory
with joystick settings, but still keeping possibility to adjust thumbstick
angle, deadzones and sensitivity.
(4) Turn LEDs off will completely turn off the Profile LEDs on the side of
the keypad.
(5) Switch to left handed will switch the button interface for keypad that
is meant for left handed people (keypad in right hand, mouse in left hand):
(6) Enable PIN editing is meant for advanced button settings, if you ever
need to change the PIN layout on the + 2.0 board.
(7) LED brightness slider adjusts the Profile LEDs on the side of the keypad.
The higher the value, the brighter the LEDs will glow.
(8) Button throttle. In case one or more of the buttons are starting to
make double clicks (switch debounce), you can setup button throttle here
in milliseconds. That is the time that must pass between keypad will
register next keypress on the same button.
Note! The button throttle currently works on all buttons in the same time,
it can’t be setup separately for each button.
