Scanning Stop
Scanning will be stopped, either in Memory Mode or UP/DOWN mode, by pressing any of the
keys or the microphone PTT switch. To resume the ‘SCAN’ mode, press the ‘SCAN’ key. But be
sure to note the following.
I) Push either UP or DOWN key to stop the scanning.
2) Scanning will be stopped by pressing other keys than UP/DOWN key. In this case, any key
other than UP/DOWN will perform the function marked on the key button.
3) If the microphone PTT switch is used to stop scanning, press the switch a Second time Will
initiate transmission. When scan is stopped at a busy channel transmission occurs immediately
when the PTT is pressed.
Priority
Pressing the PRI key will initiate priority monitoring of the frequency stored in memory channel
A0 and the PRI will be indicated on the LCD display. Then channel is monitored every four
seconds for the presence of a signal. Signal appears over the Squelch level at the frequency stored
in A0, a beep will sound twice.
To release the priority mode, press PR1 key again. The PRI indicator will disappear.
Note:
1) The dual watch operation is not carried out when calling the A0 channel
alone.
20 During the dual watch, transmission does not occur at the Priority Channel (i.e. A0)
even if the PTT switch is pressed. Be sure to press the PTT switch after calling MAO
channel.
—
12
—