Azbil F4Q, User Manual

Page: 57 / 76

6-11
Chapter 6. Communication Data
Item Data range
/ [unit]
Data address
Decimal
(hexadecimal)
R W Notes
(C-10)
Digital input 1 function
assignment
0: Not used
1: Totalized flow reset
2: Totalized flow count
pause
3: SP No. switching
4: Flow rate analog
setup
5: Operation mode
forced fully closed by
contact ON
6: Operation mode
forced fully open by
contact ON
7: SP ramp control ON/
OFF switching
8: Operation mode
switching (control
by contact ON,
forced fully closed by
contact OFF)
9: Flow rate zero
adjustment
10: Gas type setting
switching
11: Analog scaling
switching
12: SP ramp control
ramp slope
switching
13: Device status
deletion
2010 (07DA) ✓ ✓ 1: While the input is ON, the total
value remains 0 and does not
increase.
4: The analog setting is valid when
the input is ON, and the C-03
setting is valid when the input is
OFF.
5,6,8: If there is a conflict of forced
full-close and forced full-open
at two contact inputs, both
inputs will be invalid.
10: After the input is switched, the
change takes about 1 second to
be applied to the operation.
Do not execute other operations
meanwhile.
12: Used to switch the ramp slope if
C-27, SP ramp control function,
is set to “2” (Ramp control 2
enabled).
13: When the input is turned ON, the
device status (alarm, warning,
information) is deleted.
Errors are not deleted.
(C-11)
Digital input 2 function
assignment
2011 (07DB)
✓ ✓
(C-12)
Digital input 3 function
assignment
2012 (07DC)
✓ ✓
(C-13)
Automatic valve shut-
off when the totalized
flow event occurs
0: Disabled
1: Enabled
2013 (07DD)
✓ ✓
(C-14)
On/off of totalized flow
reset function at start of
control
0: Disabled
1: Enabled
2014 (07DE) ✓ ✓