Azbil AUR355, User Manual

Page: 30 / 56

20
Chapter 3. Operating This Device
Communication setting
3. After making a selection, press the RESET switch. “
H2
” blinks,
and when the blinking stops, configuration is complete.
At this time, “
H2
” is displayed.
•
Communications format setting (
H3
)
Use the DISP switch to select
H3
on the 7-segment display.
1. Press the RESET switch. The 7-segment display shows
H3
/_. _ represents 1, 2, or 4. (Default setting: 1)
1 : Even parity, 1 stop bit
2 : Even parity, 2 stop bits
3 : Odd parity, 1 stop bit
4 : Odd parity, 2 stop bits
2. When the DISP switch is pressed in this situation, the display
cycles through
→
H3
/
1
→
H3
/
2
→
H3
/
3
.
Select the communications format.
3. After making a selection, press the RESET switch. “
H3
”
blinks, and when the blinking stops, configuration is
complete.
At this time, “
H3
” is displayed.
•
Initialization of settings (
CL
)
Use the DISP switch to select CL on the 7-segment display.
1. Press the RESET switch. The 7-segment display shows
CL
/
nO.
2. When the DISP switch is pressed in this situation, the display
toggles between
CL
/
nO
(no) and
CL
/
y
(yes). Select whether
to initialize all the communication settings.
CL
/
y
Execute initialization
CL
/
nO
Cancel initialization
3. After making a selection, press the RESET switch. “
CL
”
blinks, and when the blinking stops, initialization of settings
is complete.
Settings after initialization
Display Description Initial value
H 1
Communication address
setting 1
H2
Baud rate setting 3 : 19200 bps
H3
Communications format
setting 1Even parity, stop bit1
4. After initialization, check the settings and change them as
needed.
Exit
(3) Press and hold the DISP switch for 5 s or more to end
communication setting mode. Communication setting mode also
ends in the following cases:
•
When the power is turned OFF.
•
If an alarm occurs during communication setting mode.