17
Chapter 4. Operation
4-1. Quick operation guide
Notes: Display and operating elements are only available locally if the head transmitter was
ordered with a display unit!
You have a number of options for configuring and commissioning the device:
1. Configuration programs
The configuration of FF functions and device-specific parameters is done via the fieldbus
interface. You can obtain special configuration and operating programs from various
manufacturers for these purposes.
→
2. Miniature switches (DIP switches) for diverse hardware settings, optional
You can make the following hardware settings for the Foundation Fieldbus™ interface using
miniature switches (DIP switches) on the rear of the optional display
→
Enabling/disabling the simulation mode in the Analog Input function block
Switching the hardware write protection on/off
Switching (turning) the display 180 °
Fig. 4-1. Head transmitter operating options
1 Configuration/operating programs for operation via Foundation Fieldbus™ (Foundation
Fieldbus functions, device parameter)
2 DIP switch for hardware settings is on the rear of the optional display (write protection,
simulation mode)