Azbil ALTJ 9000 Series, User Manual, Page: 27 / 68

6-1
Chapter 6 Configuration (Setting)
CAUTION
Do not perform the SFN communication when the process of the liquid level transmitter is in the
automatic control status. Doing so may cause the output to vary, resulting in a hazardous operation
status.
This chapter describes the settings that can be changed using the communicator.
For details about changing settingus, refer to the following user's manual for CommStaff.
y
Field Communication Software CommStaff Model: CFS100 Instruction Manual (Smart ALTJ™9000
Immersion-type Liquid-Level Device Edition), No. CM2-CFS100-2014.
Table 6-1. Settings that can be changed using CommStaff
Setting Details Notes
Registered Tag No. You can set a Tag No. using up to 8 alphanumeric characters and sym-
bols as shown below.
y
Alphanumeric characters: "A" to "Z", "0" to "9"
y
Symbols: " " (space), "." (period), "-" (hyphen), "/" (slash)
When changing a Tag No., make
sure that the specifications set
for this device comply with
those at the installation location.
Pressure unit Select one of the following.
y
inH
2
O, inHg, mmH
2
O, mmHg, psi, bar, mbar, g/Sqcm, kg/Sqcm, Pa,
kPa, MPa
When using this device in Japan,
be sure to select an SI unit.
Measurement range LRV and URV must be set.
y
LRV: The value that outputs 4 mA.
y
URV: The value that outputs 20 mA.
Numeric values that can be
input can have up to2 decimal
places.
Damping time
constant
Choose one of the ten steps below.
y
0 s, 0.16 s, 0.32 s, 0.48 s, 1 s, 2 s, 4 s, 8 s, 16 s, 32 s
If any other value is set, it is
replace with the nearest of the
values on the left.
Forced writing The setting is forcibly written to nonvolatile memory --
Memo A memo can consist of up to 32 of the alphanumeric characters and
symbols shown below.
y
Alphanumeric character: "A" to "Z", "0" to "9"
y
Symbol: " " (space), "." (period), "-" (hyphen), "/" (slash)
--