STEP 11:
Assemble the mesh guard(B) into the heater to match the hook in the aluminum tubes,then screw
the guard fastening pieces(H) together with matching 3/16 screws on the top of the upper plate to
STEP 12:
Screw the knob with the chain(P) into the front panel(L).
Fix the heater with ground fixer(DD
）
.
OPERATION
Preparation:
You will need to purchase a LPG cylinder designed to be used with the
regulator purchased.
Connect the regulator to the LPG cylind
er.
Warning:
Always test the hose for leaks with soapy water at both of the ends.
Any guard or protective device removed for servicing the heater must be
replaced prior to operation.
Warning:
Never use the heater while it is raining, the glass tube would break when it suddenly met water.
Always turn off the heater while there is a rain.
Never splash any liquid
on
the glass tube when the heater is working
.
The glass tube will be extremely hot when it is working, never try to touch it and Keep the children
away from the heater.
Always ensure the heater stands firmly, the glass tube may break if the heater was to fall down
onto the ground.
Never use the heater if the glass tube has any crack
LIGHTING INSTRUCTIONS:
Check and ensure that an AA battery is inside the ignition
chamber and has power. Ensure the anode(+) faces outside.
Warning:
Ensure that the control knob is OFF. Slowly open the gas
cylinder valve.
Press and turn the control knob to LIGHT position, push
the igniter to generate spark while keeping control knob in
pressed position
Check for pilot flame through glass tube. If pilot does not
light, turn control knob to ‘OFF’ position wait two minutes
minimum and try again from the start. Some attempts may be
necessary.
If the pilot alight, keep control knob pressed for 15 seconds
then turn the control knob to ‘LOW’.
For maximum heat turn control knob to ‘HIGH’.
To turn heater off, turn control knob to ‘OFF’.
Close the v
al
ve
on
the gas cylinder or the regulator after use.
1.
2.
3.
4.
5.
6.
7.
OFF
LIGHT
LOW
HIGH
FOR YOUR SAFETY:
● DO NO
T touch or move heater for at
Least 45 minutes after use.
●
Allow all burner elements to cool before
Touching.
●
In a salt-air environment (such as
near an Ocean) corrosion occurs more
quickly than normal.
●
Frequently check for corroded areas
and Repair them promptly.
●
Wait until heater is cool before
covering.
WARNING
NOTE
12
13
OFF
LO
HI
