STEP 5:
Install 4 pieces of connected tube on
the top of the pre-assembled base(PART GG).
Screw the bolts at the bottom tightly.
(PART B 16PCS)
STEP 6:
Open the flame screen carton, take out the flame
screen (PART AA) to the top of the aluminium tubes using
hardware provided (PART B 8PCS)
STEP 7:
Take out 3 two sided bolts (Part A) out of
screw pack, and connect to flame screen(Part AA). Attach
reflector(Part G) through the 3 bolts. Then tighten the
shield with the 3 wing nuts.
STEP 3:
Mount the stabilty ring(PART H) to the
base of the heater.
STEP 8:
Open the glass tube box and take out the glass tube
(PART EE). Squeeze the stainless steel ring together(PART DD),
and carefully slide the ring inside one end of the
glass tube( PART EE).
STEP 4:
Open the aluminium tube carton, take out
all of the aluminium tubes (PART CC) Connect two
tubes together. Screw the bolts in the middle position
tightly using the hardware provided (PART B 8PCS).
