A SAFE LOCATION FOR THE HEATER
CAUTION
When objects are left under a heater in operation, they will be subject to radiant heat
and may be damaged.
● The principal application of this heater is to give the comfort of heat to pools, patios,
spa areas, terraces, work areas, etc.
This heater is approved for outdoor use only.
● Provide fresh air ventilation at all times
● Respect minimum clearances to combustibles as shown in the figure below.
● Install heater on a level, solid and stable ground.
● Do not install in an explosive environment. Keep away from areas where gas,
vapors or flammable liquids are stored or used.
● In case of high winds, shut-off the heater completely and the cylinder gas valve.
Remove reflector dome.
● Do not move the heater when hot.
CLEARANCES FROM COMBUSTIBLES
Respect clearances as shown:
-
Sides of reflector : 24 inches
-
Above reflector : 18 inches
OPERATION
TO LIGHT-UP
1. Open valve at gas tank.
2. From OFF position, depress knob, turn 90° counter clockwise and hold.
3. While depressing control knob, for at least 45 seconds, then press spark igniter
button to light up burner. You may have to push it more than once. When flame is
visible, keep control knob depressed
for 30 seconds.
If igniter fails to light the burner after 8 seconds, release control knob, turn to
OFF and wait 5 minutes.
If gas hose is connected for the first time or to a refilled tank, it will take about
1 minute to purge the line to empty its air and to allow gas to reach the burner.
4. Release control knob, burner flame should stay lit.
If not, repeat steps 1 to 4 or you may light with a match.
5. Turn control knob to HI for maximum heat.
TO TURN OFF
1. Push and turn control knob clockwise to OFF
2. Turn off valve at gas tank.
-5-
