Ayrton magicpanel 602, User Manual

Page: 7 / 20

USER MANUAL _
7
1. LCD display
2. Left button
3. Down button
4. Enter button
5. Right button
6. Handle
7. Up button
8. MODE/ESC button
9. Collimators
10. Antenna - Wireless DMX
11. DMX512 output connector (5-pin)
12. DMX512 input connector (5-pin)
13. RJ45 output connector
14. RJ45 input connector
15. Fuse holder
16. Power source input connector
17. Power source output connector
InStALLAtIon InStructIonS
During installation please observe the instructions according to
GB7000.15 / EN60598-2-17 standards and other national standards
applicable.
This luminaire should be installed by a qualified technician.
The fixture should be used in an environment with a temperature between
-5 °C and +45 °C. Do not operate the luminaire outside this temperature
range.
The luminaire must be hung so that the weight of this unit multiplied by
10 can be sustained for 1 hour without causing the suspension system or
the supporting structure to be deformed.
The installation must always be secured at a second attach point, e.g., by
a safety cable of the appropriate size.
Do not stand under the luminaire while it is being installed, dismantled
or serviced.
The operator must ensure that a qualified technician has approved the
installation of the luminaire for safety before it is first operated.
Installation should be inspected once a year by a qualified technician.
WArnInG!
The installation of this luminaire must be validated by a qualified
technician before it is used for the first time.
The luminaire should be installed in a location where the public cannot,
touch, walk or sit on the luminaire.
Suspending the luminaire and/or installing it high up requires considerable
experience, e.g., calculating load, selecting and adapting quality fastening
materials, and periodically inspecting the entire installation. Without this
skill and knowledge, do not attempt to install this unit by yourself. Improper
installation may cause an accident resulting in personal injury or death.
WArnInG!
The luminaire should be connected to an electrical source by a
qualified electrician.
Before installing the luminaire make sure that the selected installation
spot can support at least 10 times the weight of the unit. Connect the
luminaire to the power source by the power cord.
InStALLAtIon mEtHod uSInG truSS HooKS
Refer to the following diagram:
• Attach the clamp to the omega bracket using an M12 screw.
• Insert the quick-lock fasteners of the first omega bracket into the
respective holes on the base of the unit. Turn the quick fasteners fully
clockwise.
• Install the second Omega bracket.
• Insert the safety cable through the holes at the bottom of the base and
the truss or a stable attachment point. Insert the end into the hole and
tighten the safety screw.
Note: This step is very important to ensure that the luminaire does not fall.
dmX512 connEctIon
Connect the DMX input (XLR connector) cable of the luminaire to the DMX
output (female XLR connector) of your controller.
You can connect multiple luminaires to this same DMX line in a daisy
chain.
The DMX cable must be a shielded twisted pair that is equipped with male
and female XLR connectors.