4.) Start an Internet browser (Internet Explorer,
Firefox, Chrome, Safari, etc.)
5.) On the uRL line, type:
10.0.0.1
and press
Enter
on your keyboard.
6.) The login page of the router should be on your
screen. If it is not, see the Troubleshooting
section below.
7.) Enter
ayrmesh
for the username and
ayrmesh
for the Password.
8.) Press
Enter
on your keyboard or press the
Login
button.
9.) The Opening Screen for the Router should be on the screen.
10.) Click on the text that says,
Click HERE
to set up your router.
11.) The next screen allows you to select how you
connect to the Internet. note that there are
three choices:
- DhcP
— this is the default, and the most
common choice. Most Cable and Satellite
Modems, as well as most “fixed wireless” systems
and any connection that uses an “all-in-one”
router that cannot be replaced (e.g. AT&T
u-Verse) use DHCP. If you’re not sure which one
to choose, this is the best guess. You don’t need
any additional information if your connection uses DHCP.
- PPPoe
(Point-to-Point Protocol over Ethernet) — this is used primarily by DSL
systems. It uses a username and Password, provided by your Internet Service
Provider (ISP), to authenticate you. You’ll need that username and Password.
- Static
— usually, you have to ask specifically for a static IP address and the ISP
will charge you extra for it. However, some fixed wireless systems use static IP
addresses for all connections. All you need to know are the address settings
from your ISP.
Ayrstone AyrMesh Router HP Setup
4