Operation and Mounting
To activate the device, plug it into a mains socket. Once it's connected to an active power source, it will turn
on automatically.
During start up, either ‘AYRA’ or a specific code will be shown on the display, which means the device is not
ready to be operated. Once the device has fully started up, it will jump to the last-used mode. Operation
modes and other settings shown on the display can now be adjusted or changed by means of the menu
buttons.
Should the device detect a DMX signal, it will automatically switch to DMX mode and will display the last-
used address. For new devices, this will normally be DMX address 001. Of course, you can change the DMX
address via the display using the menu buttons.
Using the display and the menu buttons, you can adjust the functions and settings of the device. Press
'Enter' to confirm an adjustment or select a function, use ‘Up’ and ‘Down’ to change values press ‘Menu’ to
go back to the menu.
Changed settings or functions can be confirmed by pressing ‘Enter’. After several seconds, the device will
automatically return to the main menu and perform its actions. This process can be sped up by holding down
the ‘Menu’ button for two seconds after confirming changes with ‘Enter’.
The menu contains the following options and settings:
display
Mode
Function
ADDR
DMX Address Configuration
Address A001 … A512
SLND
Slave Mode
Master - NAST
Slave 1 – SL 1
Slave 2 – SL 2
SHND
Show Mode (meant for sound-
controlled operation)
SH 1 – Show program 1
SH 2 – Show program 2
SH 3 – Show program 3
SH 4 – Show program 4
SOUN
Sound-controlled mode (activates
internal microphone)
Mode: ON / OFF
SENS
Sound Sensitivity
000 – 100: Sensitivity in %
LED
LED Display on/off if not in use
ON/OFF
DISP
Display inversion
Display inversion, Idsp-dspI
PAN
Pan Inversion (mirroring)
NO – No inversion pan
YES – Inversion pan
TILT
Tilt Inversion (mirroring)
NO – No inversion tilt
YES – Inversion tilt
TEST
Test Mode
Test program to check if all functions are
working properly
HOUR
Operating Time Registration
0000 – 9999 Operating hours
VER
Firmware Version
Displays firmware version (cannot be updated by
end users)
RSET
Reset Function
Resets the device
The different functions explained:
ADDR:
With this function, you can determine the DMX start address of the device. Set it channel 001, and the
device will read DMX channel 1. Set it to channel 003, then the device will read DMX channel 3, etc.
SLND:
The Master-Slave mode is designed to sync multiple devices. A copy of the internal program is sent
to the daisy-chained devices so that each one projects the same effect. The master-slave function works by
The information in this user manual is subject to change at any time without notice.
Version: 1.0
Date of creation and author's initials: 07-10-2019 RV
Revision date and author's initials: -
