150-CFL-190(-)
11
4
Section
Chassis Mounting Procedure
The chassis is provided with two top and two bottom mounting tabs so that the chassis
can be mounted to the inside of a hole opening the size as shown in the mechanical
drawing. The attachment can be from resident panel studs or screws from the front of
the panel with nuts and washers from the rear.
The standard chassis comes with a tempered glass window as to protect the LCD
(unless a touch screen is installed).
Front sealing, if necessary, is up to the customer.
Attach the power, video and touch screen cables (if applicable) to the side of the
monitor.
Panel Mounting Procedure
The unit should be inserted into the opening per the dimension drawing. This will expose
12 female studs. The panel mount should be held in place by using the clips as shown
below. Each clip has three holes. The center hole accepts a small 3mm screw. The
outboard holes accept the larger 3mm screw which will put pressure on the users
metalwork outboard of the cut out. When all 12 clips are in place, this will put uniform
pressure on the perimeter surface around the cut out securing the panel to a NEMA
4/IP65 seal.
Mounting
Instructions
Summary of Contents for CAMBRIDGE CFL19P1
Page 19: ...150 CFP 190 19 Appendix E Mounting Dimensions CFP19C1 Chassis Outline Dimensions Unavailable...
Page 20: ...150 CFP 190 20 Appendix E Mounting Dimensions CFL19P1 Panel Mount Outline Dimensions...
Page 21: ...150 CFP 190 21 Appendix E Mounting Dimensions CFL19R2 Rack Mount Outline Dimensions...
Page 22: ...150 CFP 190 22 Appendix E Mounting Dimensions CFL19W1 VESA Wall Mount Outline Dimensions...