GB
48
|
49
BEFORE INSTALLATION:
Please always keep original package, so after your seasonal use, you can re-pack them for
storage.
Metal base
Fixing Big screws &
nuts (4pcs)
Fixing Small screws &
nuts (8pcs)
Outer pole
Inner pole with
Fixed knob
Mist motor assembly
Fan motor
Control box
assembly
Fan blade with
fixing bolt
Rear grille &
front grille
Water tank
Wheels
Wheels with locking
fixation
Connect hose
Electrical water
pump
ASSEMBLY
Warning! Please make sure the power supply is disconnected before assembly.
Select a flat area about at least 2 x 2 m to install this fan.
NO.
Picture
Remark
Use the supplied 4 big fixing screws
(A,B,C,D, each of 1pc) with nuts and 8 small screws
(E,F,G,H, each of 2pcs) to install the metal base as
left photo.
Loose out the allen screw A of outer pole with hex key.
And then put the black connector B out.
For this step, please pay attention to the pole direction
which is down for fixed screw A (see the arrow), put the
connector B into the inner pole according to this direction.
Then take the inner pole into the outer pole. Loose the
fixing screw on the outer pole and install it on the metal
base and re-tighten them. Refer to left photo.
Fit the control box assembly onto the inner pole,
and tight it with screw.
Then assemble the 6 wheels: 4 wheels
(Wheel A,B,C,D)and 2 wheels (Wheel E,F)
with locking fixation.
1
2
3
4
5
6
Fit the fan motor onto the control box and tight with
the screw.
7
A
B
C
D
E
G
H
F
A
B
D
C
E
F
B
A
B
A
A
