process, which takes "pump water in for 30 seconds---water tank run to
drain out water" as a circle, and this circle will run for 5 times. Flashing of
indicators of "S" and "L" will take place in turn until self-clean process is
over and the machine enters standby mode. Take away the plastic plug to
drain water and then whole process is finished.
When the indicator of this button turns to red, it means insufficient water to
water reservoir, you need to add enough water and press POWER button to
restart the machine.
When the ice reach to the max storage capacity, the indicator of this button
will flash, and the machine will stop working. What you need to do is pouring
out the ice, if the position of ice is lower than the position of ice bin full
sensor, the machine will restart automatically.
Operating Instructions
Note: Water reservoir and pipeline should be well cleaned before use.
Step 1. Plug out, and clean the water reservoir by adding water, then take plastic plug
away to drain out the water from water reservoir.
Step 2. Reinstall the plastic plug, and add appropriate clean water. After connecting the
power supply well, press and hold "SELECT" button for 3 seconds to activate
pipeline self-clean process. After cleaning, drain out the water by taking plastic
plug away.
Step 3. Open the lid and take out the ice basket to add appropriate water into water
reservoir.
Note: The water poured into water reservoir should be lower than the water reservoir’s
MAX position. When water volume goes beyond the max, please open the bottom
water drain plug to drain the spare water out. Then close the transparent lid.
Step 4. Select the desired ice size, the default size of machine is large one.
Note: Please select the (S) when ambient temperature is below 15°c.When the ambient
46
47
GB
Summary of Contents for 7613164553461
Page 51: ...54 55 GB...
Page 52: ......
