- 18 -
IMPORTANT! -There is a need of good ventilation around the fridge for easy
dissipation of heat, high efficiency of refrigeration and low power consumption.
For this purpose, sufficient clear
Well Ventilating
space should be available around the fridge. It is
advisable for there to be 75mm separating the back
of the fridge to thewall, at least 100mm of space at its
two sides, height of over100mm from its top and a
clear space upfront to allow thedoors to open
160°
.
Appliances must not be exposed to rain. Sufficient air must be allowed to circulate in
the lower rear section of appliances, as poor air circulation can affect performance.
Built-in appliances should be positioned away from heat sources such as heaters
and direct sunlight
Power Line Cord
The cord should be neither lengthened nor folded into
coil during operation.Moreover,it is forbidden that the
cord is keept close onto the compressor at the back of
the fridge,the surface temperature of which is quite high
when operating.Touching with it may melt the insulation
and cause electrical leakage.
REVERSING THE DOOR
When changing the side at which the door opens, the appliance must not be
connected to the mains. Remove plug from the mains beforehand.
The side at which the door opens can be changed from the right side (as supplied)
to the left side, if the installation site requires.
Before you start lay the freezer on it’s back in order to gain access to the base,you
should rest it on soft foam packaging or similar material to avoid damaging the
cooling pipes at the rear of the freezer.
