XSVI-9004-NAV
Connections to be made
For BOSE systems:
• Connect the
White
RCA to the left front RCA output.
• Connect the
Gray
RCA to the right front RCA output
• Connect the
Green
RCA to the left rear RCA output.
• Connect the
Purple
RCA to the right rear RCA output
Tape off and disregard the following wires, they will not be used in
this application:
• The
Green
,
Green/Black
,
Purple
,
Purple/Black
,
White
,
White/Black
,
Gray
,
and
Gray/Black
wires.
Note:
It is highly recommended that the radio being used has 2 sets
of RCA outputs to retain balance and fade; 3 sets if a sub-woofer amplifier
will be added.
(c) From the 12-pin harness (ASWC-1 pre-wired harness):
• This harness is to be used in conjunction with the optional ASWC-1
(not included) to retain steering wheel controls. If the ASWC-1 is not being
used, disregard this harness. If it will be used, please refer to the ASWC-1
instructions for radio connections and programming.
Note:
Disregard the harness that comes with the ASWC-1.
With the key in the off position:
• Connect the 12-pin harness into the interface.
• Connect the 40-pin harness into the vehicle.
• With all connections completed, reconnect the negative battery terminal.
• Initialize the interface by turning the ignition on for 30 seconds, then turn the
ignition back off, then back on again.
Note:
If using the ASWC-1, connect it after you initialize the XSVI-9004-NAV, with
the key in the off position.
Installing the XSVI-9004-NAV
• If the vehicle has engine noise after installing the XSVI-9004-NAV, use Axxess
part number AX-AGL610, qty. (2).
Troubleshooting
