AXGMLN-01
3
Connections to be made
From the AXGMLN-01 harness to the aftermarket radio:
• Connect the
Black
wire to the ground wire.
• Connect the
Yellow
wire to the battery wire.
• Connect the
Green
wire to the left rear positive speaker output.
• Connect the
Green/Black
wire to the left rear negative speaker output.
• Connect the
Purple
wire to the right rear positive speaker output.
• Connect the
Purple/Black
wire to the right rear negative speaker output.
• The
Black/Yellow
wire is used for OnStar level adjustment for models that
do not come equipped with steering wheel controls. See the OnStar level
Adjustment section for further instructions.
12-pin pre-wired AXSWC harness:
• This harness is to be used along with the optional AXSWC (not included)
to retain steering wheel audio controls. If the AXSWC is not being used,
disregard this harness. If it will be used, please refer to the AXSWC
instructions for radio connections and programming.
Note:
Disregard the harness that comes with the AXSWC.
• Connect the
Red
wire to the accessory wire.
Note:
The relay attached to the AXGMLN-01 harness is only for audible turn signal
clicks. No extra steps are required to retain this feature, so leave the relay as-is
.
Backup camera harness (if applicable):
• If retaining the factory backup camera, connect the
Yellow
RCA jack to the
backup camera input of the aftermarket radio.
With the key in the off position:
• Connect the 16-pin harness with stripped leads, and the AXGMLN-01 harness,
into the interface.
• Connect the AXGMLN-01 harness to the wiring harness in the vehicle.
• If using the AXSWC, connect it after you initialize and test the AXGMLN-01, with
the key in the off position.
• If applicable, connect the backup camera harness to the wiring harness in the
vehicle. This harness is located behind the radio.
Attention!
If the interface loses power for any reason, the following steps will need
to be performed again. Also, if installing an AXSWC connect it after you initialize and
test the interface/radio, with the key in the off position.
• Turn the key (or push-to-start button) to the ignition position and wait until the
radio comes on.
Note:
If the radio does not come on within 60 seconds, turn the key to the
off position, disconnect the interface, check all connections, reconnect the
interface, and then try again.
• Turn the key to the off position, pause for a moment, and then to the accessory
position. Test all functions of the installation for proper operation, before
reassembling the dash.
Installing the AXGMLN-01
Initializing the AXGMLN-01
