3
REV. 11/3/2020 INSTAXDSPL-WR
1.
Install the
AXDSPL-WR harness
and make all necessary connections to the radio and
vehicle, but leave the amp turn-on wire disconnected.
2.
With the arrow stamped onto the cap facing upwards, push the 16-pin connector from
the
AXDSPL-WR harness
harness into the left side of the cap. The locking clip on the
connector should face upward. Make sure the gasket is seating properly in the cap.
(Figure A)
3.
With the arrow stamped onto the cap still facing upwards, push the 20-pin connector
from the
AXDSPL-WR harness
into the right side of the cap. The locking clip on the
connector should face upward. Make sure the gasket is seating properly in the cap.
(Figure A)
4.
Plug the 16-pin and 20-pin connectors from the
AXDSPL-WR harness
into the
AXDSP-L
circuit board
. (Figure A)
5.
Slide the assembly into the case, then click it shut. Zip-tie the enclosure to a secure
location. Make sure the Axxess logo is facing up to further ensure that no outside
elements can enter the enclosure.
INSTALLATION
Cap (with O-ring)
Case
AXDSP-L
Circuit Board
AXDSP L
Harness
16-Pin
20-Pin
Gasket
Zip-tie Mounts
Continued on the next page
(Figure A)
