5
REV. 7/19/2018 INSTAX-AU12-SWC
Attention!
This interface will work with models that are either Bose amplified, or non-Bose
amplified. Please follow the instructions carefully for your model vehicle. Failure to do so will
result in improper sound. If you are unsure if your vehicle is Bose amplified or not, please contact
your local dealership.
For models equipped
without
a Bose sound system:
From the 16-pin harness with stripped leads to the aftermarket radio:
• Connect the
Red
wire to the accessory wire.
• If the aftermarket radio has an illumination wire, connect the
Orange/White
wire to it.
• Connect the
Blue/White
wire to the amp turn on wire.
• Connect the
Purple
RCA jack to the right rear RCA output.
• Connect the
Green
RCA jack to the left rear RCA output.
• Disregard the
Gray
RCA jack, it will not be used in this application.
• Disregard the
White
RCA jack, it will not be used in this application.
The following (3) wires are for multimedia/navigation radios that require these wires. If not
required, tape them off and disregard them.
• Connect the
Blue/Pink
wire to the VSS/speed-sense wire.
• Connect the
Green/Purple
wire to the reverse wire.
• Connect the
Light Green
wire to the parking brake wire.
• Tape off and disregard the following (9) wires, they will not be used in this application:
Purple
,
Purple/Black
,
Green
,
Green/Black
,
Gray
,
Gray/Black
,
White
and
White/Black.
From the LD-BX-AU2 harness to the aftermarket radio:
• Connect the
Black
wire to the ground wire.
• Connect the
Yellow
wire to the battery wire.
• Connect the
Blue/White
wire to the amp turn on wire.
• Connect the
Gray
wire to the right front positive speaker output.
• Connect the
Gray/Black
wire to the right front negative speaker output.
• Connect the
White
wire to the left front positive speaker output.
• Connect the
White/Black
wire to the left front negative speaker output.
• Tape off and disregard the following (4) wires, they will not be used in this application:
Purple
,
Purple/Black
,
Green
and
Green/Black
.
Continue to 3.5mm jack steering wheel control retention
CONNECTIONS TO BE MADE
(LD-BX-AU2 APPLICATIONS)
