3
REV. 7/19/2018 INSTAX-AU12-SWC
CONNECTIONS TO BE MADE
(LD-BX-AU1 APPLICATIONS)
Attention!
This interface will work with models that are equipped with or without a Bose ampli-
fier. Please follow the instructions carefully for your model vehicle. Failure to do so will result in
improper sound. If you are unsure if your vehicle is equipped with a Bose amplifier or not, please
contact your local dealership.
For models equipped
without
a Bose sound system:
From the 16-pin harness with stripped leads to the aftermarket radio:
• Connect the (2)
Red
wires to the accessory wire.
• Connect the
Orange
wire to the illumination wire. If the aftermarket radio does not have an
illumination wire, tape off and disregard the
Orange
wire.
• Connect the
Blue/White
wire to the amp turn on wire. This wire must be connected to hear
sound from the factory amplifier.
Note:
There is a
Blue
wire on the LD-BX-AU1 harness to connect as well.
The following (2) wires are for multimedia/navigation radios that require these wires. If not
required, tape them off and disregard them.
• Connect the
Green/Purple
wire to the reverse wire, if applicable.
• Connect the
Light Green
wire to the parking brake wire, if applicable.
• Tape off and disregard the following (9) wires, they will not be used in this application:
Blue/Pink
,
Green
,
Green/Black
,
Purple
,
Purple/Black
,
White
,
White/Black
,
Gray
and
Gray/
Black
.
From the LD-BX-AU1 harness to the aftermarket radio:
• Connect both the
Black
and
Black/White
wires to the ground wire.
• Connect the
Yellow
wire to the battery wire.
• Connect the
Blue
wire to the amp turn on wire. This wire must be connected to hear sound
from the factory amplifier.
The following (1) wire is for a multimedia/navigation radio that requires this wire. If not
required, tape it off and disregard it.
• Connect the
Blue/Pink
wire to the speed sense wire (V.S.S.), if applicable.
• Connect the
Green
RCA jack to the left rear RCA output.
• Connect the
Purple
RCA jack to the right rear RCA output.
• Disregard the
White
RCA jack, it will not be used in this application.
• Disregard the
Gray
RCA jack, it will not be used in this application.
• Connect the
Gray
wire to the right front positive speaker output.
• Connect the
Gray/Black
wire to the right front negative speaker output.
• Connect the
White
wire to the left front positive speaker output.
• Connect the
White/Black
wire to the left front negative speaker output.
• Tape off and disregard the following (4) wires, they will not be used in this application:
Green
,
Green/Black
,
Purple
and
Purple/Black
.
Continue to 3.5mm jack steering wheel control retention
