5
Set the High Temperature Limit Stop (optional)
Close the drain, or place a rag in the bottom of the
sink to prevent parts from falling down the drain.
Use a 4 mm allen wrench to push the gray rubber
screw cover through the handle. Turn the screw
4 complete turns counter clockwise.
Remove the handle.
If necessary, turn the stem so that it is
centered. Remove the screw. Remove
the green high temperature limit stop.
Reinstall the limit stop so that the pin is
in the desired slot on the limit stop. The
degree markings shown on the diagram
assume an incoming hot water tempera-
ture of 140
o
F and a incoming cold water
temperature of 50
o
F.
Thread the handle screw back into the
stem, giving it four complete turns clock-
wise. Replace the handle. Finish tighten-
ing the screw. Replace the screw cover.