consistent with that matched the
machine).
·
Fit outer flange（3）and nut (4).
·
Screw down nut(7) with 18mm spanner.
·
Fix the outer guard(5) of the grinding
wheel properly with bolt (6).
·
According to the above, adjust eye
shield bracket, adjustable tool test
and eye shield.
When replace the flange (1) and
法兰(1(3),the diameter of the flange
used should be at least 1/3 diameter of
the grinding wheel, and their apertures
are consistent. The swing measured from
the grinding wheel circumference is
normal. The axial wobble and the radial
wobble within 0.5mm are normal swing.
Usage
·
Check that all the parts are well
fitted or adjusted.
·
Start the bench grinder.
·
Let the bench grinder work at
rated speed so that it can polish
well.
According to different results of polishing, you
should choose different grinding wheels.
·
If necessary, you should polish working
pieces with rough grinding wheels firstly,
and then with fine grinding wheels.
·
Before polishing, check the working piece
usually to make sure that there’s no oil,
grease and painting feculence to avoid being
blocked up or becoming dirty
·
Avoid the bench grinder over-heated.
·
The working piece can only bear slight press.
·
If blocked up, you can repair it with D-Mart
handle repairing machine.
Maintenance and Cleaning
Using the grinder under low load requires no
maintenance.
Clean the bench grinder regularly..
Remove dust and dirt produced by polishing
with a soft brush.
Environment Protection
Putting away waste grinding wheel should
according to the requirements of environment
protection.
Picture A (RBG150ID)
