!
WARNING
Disconnect machine from the power
source
!
No mater when, where, or how. Pay
extra attention to the saw during it in
transportation, operation, maintenance,
or adjustment.
Failure to comply may cause serious
injury
!
CHANGING BLADE
1. Raise this saw head up-to 90 degree by
lifting up knob (A) in Fig. 5 a little bit to
release the lock-pin, and slide it into the
slot that is made for setting the saw arm
in vertical position.
2. Remove this blade guards (B), and blade
cover by loosening two bolts (C) on the
saw frame.
3. Push tension handle (D). Counter wise to
let the blade slip off.
4. Remove blade from both wheels (E), and
blade guide bearing (F).
5. Place a new blade on the flanges of
wheels but not too tight, twist blade
slightly and let it slip into between each of
guide bearings. Make sure the teeth of
blade face down toward the bed
6. Fasten the tension handle clockwise
move the blade by pulling it down with
one hand and it will be tracked onto
wheels properly.
7. Replace blade cover (G) and guards. And
start the machine to see that the blade
runs properly.
Fig. 5
