Axminster CQ6230A-2/910, User Manual

Page: 22 / 69

OWNER’S MANUAL
Page - 21 -
6. MECHANISM’S ADJUSTMENT
All the mechanisms are adjusted and tested in the producer’s plant. After a
prolonged exploitation, some of the mechanisms have to be readjusted
because of the wearing off of the friction surfaces. The adjustment and setting
of the different mechanisms shall be effected after each machine repair too.
It is recommended these adjustments to be performed by qualified specialists
in respective service.
7. SAFETY
All lathe operators must be constantly aware of the safety hazards that are
associated with using the lathe and must know all safety precautions to avoid
accidents and injuries.
Some important safety precautions to follow when using the lathe are:
1. Correct dressing is important, remove rings and watches, roll sleeves
above elbows.
2. Always stop the lathe before making adjustments.
3. Do not change spindle speeds until the lathe comes to a complete stop.
4. Handle sharp cutters, centers, and drill with care.
5. Remove chuck keys and wrenches before operating
6. Always wear protective eye protection.
7. Handle heavy chuck with care and protect the lathe ways with a block of
wood when installing a chuck.
8. Know where the emergency stop is before operating the lathe
9. Use pliers or a brush to remove chips and swarf, never your hands.
10. Never lean on the lathe.
11. Never lay tools directly on the lathe ways. If a separate table is not
available, use a wide board with a cleat on each side to lay on the ways.
12. Keep tools overhang as short as possible.
13. Never attempt to measure work while it is running
14. Never file lathe work unless the file has a handle.
15. File left-handed if possible
16. Protecting the lathe ways when grinding or filing.
17. Use two hands when sanding the work piece. Do not wrap sand paper or
emery cloth around the work piece.